Honda S2000 trunk components and testing applies to 1999-2003 models.
Trunk Wiring Diagram
SWITCH TEST
1. Remove the rear console.
2. Disconnect the 2P connector from the switch.
3. Check for continuity between the No. 1 and No. 2 terminals.
- There should be continuity when the switch is pushed.
- There should be no continuity when the switch is released.
4. If the continuity check is not as specified, replace the switch.
SOLENOID TEST
- Open the trunk lid.
- Disconnect the 3P connector from the trunk latch.
- Check solenoid operation by connecting power and ground according to the table. To prevent damage to the solenoid, apply battery voltage only momentarily.
- If the solenoid does not operate as specified, replace it.
Got questions and comments on Honda S2000 trunk? Let us know below.
{ 2 comments… read them below or add one }
Hi, I have a question. I have an s2000 with a rear view camera installed in they key hole, but it no longer opens. When I press the button from inside the glove compartment, it doesn’t open or click either. When this first happened, I couldnt use it for a few days, then one day, I decided to try it out, and it magically worked again. Then the day right after, it stopped working for good. Every since then (8 months ago) it stopped working. I can’t open my trunk manually, and I checked the fuse and it seemed fine. I was wondering if you had any suggestions since I cannot get my trunk to open. Thanks!!
I have a ’07 S2000 and want to switch out a winged trunk lid with a non winged one from another owner. Question is, what’s necessary from a lock standpoint in making the switch? Both electronically and mechanically.
Thanks