HONDA S2000 FRONT AND REAR BRAKE CALIPER OVERHAUL
Remove, disassemble, inspect, reassemble, and install the caliper and not these items:
- Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the pain, was it immediately with water.
- To prevent dripping, cover disconnected hose joints with rags or shop towels.
- Clean all parts in brake fluid and air dry; blow out all passages with compressed air.
- Before reassembling, check that all parts are free of dirt and other foreign particles.
- Replace parts with new ones as specified in the image.
- Make sure no dirt or other foreign matter gets in the brake fluid.
- Make sure no grease or oil gets on the brake discs or pads.
- When reusing pads, always reinstall them in their original positions to prevent loss of braking efficiency.
- Do not reuse drained brake fluid.
- Always use Honda DOT 3 brake fluid.
- Coat the piston, piston seal groves, and caliper bore with clean brake fluid.
- Replace all rubber parts with new ones.
- After installing the caliper, check the brake hose and line for leaks, interference, and twisting.
FRONT CALIPER
REAR CALIPER
Got questions and comments on how to overhaul the Honda S2000 brake calipers? Let us know below.