Removing and installing oil seals applies to all Acura Integra Models between 1994-2001.
Front Crankshaft Oil Seal Removal
Remove timing belt. Remove crankshaft timing belt sprocket. Remove front crankshaft oil seal.
Front Crankshaft Seal Installation
Lubricate crankshaft and oil seal lip with grease. Install oil seal using Seal Driver (07LAD-PR4010A) until seal driver bottoms against oil pump. To complete installation, reverse removal procedure.
Rear Crankshaft Oil Seal Removal
- Disconnect negative battery cable. Remove transaxle assembly.
- On manual transmission models, place reference marks on clutch pressure plate and flywheel for installation reference. Remove pressure plate and clutch disc. Remove flywheel. Remove seal.
When installing NEW crankshaft oil seal, align hole in Driver Attachment (07948-SB00101) with pin on crankshaft.
Rear Crankshaft Oil Seal Installation
Apply a light coat of engine oil to crankshaft and lip of new seal. Using Seal Driver (07749-0010000) and Driver Attachment (07948-SB00101), install NEW seal. To complete installation, reverse removal procedure.
Got questions and comments on how to remove and install oil seals for Acura Integra 1994-2001? Leave them below!
