HONDA CIVIC 1992-1995 MASTER CYLINDER REMOVAL AND INSTALLATION
Drain master cylinder reservoir. Disconnect fluid level switch connector. Disconnect brake fluid lines. Plug openings to prevent fluid loss and contamination. Remove master cylinder mounting nuts. Remove master cylinder. Bleed master cylinder before installation. To install, reverse removal procedure. Bleed system as necessary. See brake bleeding procedure located on top of this page.
POWER BRAKE BOOSTER REMOVAL
Power brake booster may be removed with master cylinder attached, if desired. Disconnect vacuum hose from power brake booster. From inside vehicle, remove retaining clip from booster rod pin on brake pedal. Remove pin from brake pedal. Remove brake booster mounting nuts. Remove power brake booster assembly from engine compartment.
POWER BRAKE BOOSTER INSTALLATION
Check length of brake booster rod. Install power brake booster. Tighten mounting nuts to specification. To complete installation, reverse removal procedure. Bleed system as necessary. See brake bleeding procedure located on top of this page.
TORQUE SPECIFICATIONS
Ft. Lbs. (N.m)
- Backing Plate Mounting Bolt: 48 (65)
- Brake Pedal Rod Lock Nut: 11 (15)
- Caliper Guide Pin Bolt (Front) Civic & Civic del Sol
- “A” Bolt: 26 (35)
- “B” Bolt: 20 (27)
- Caliper Mount Bracket Bolt
- “Front: 81 (110)
- “Rear :29 (39)
- Flexhose-To-Caliper Banjo Bolt: 26 (35)
- Master Cylinder-To-Power Unit Nut: 11 (15)
- Power Booster Push Rod Lock Nut: 11 (15)
- Rear Spindle Nut: 136 (185)
INCH Lbs. (N.m)
- Caliper Shield: 89 (10)
- Power Booster Mounting Nut: 115 (13)
- Rear Wheel Cylinder Mounting Nut: 80 (9)
Got questions and comments for how to remove and install brake master cylinder and power booster for Honda Civic 1992-1995? Let us know below!