How To Jack Up Or Hoist Mazda RX7 (FD3S)

by NinjaX on January 10, 2011

Following illustrations indicate areas (parts) of underbody and frame which may be used to raise and support vehicle using either floor jack or hoist. These points are indicated by shaded areas on frame. See top image.

Do not interfere with shock absorber mounting brackets or stabilizer bar mounting brackets.
[click to continue…]

{ 1 comment }

RX7 Cooling System Specs (FD3S)

by NinjaX on July 10, 2010

Mazda RX7 cooling system specs applies to 1993-1995 FD3S models.

  • Coolant Replacement Interval: 30,000 Miles Or 24 Months
  • Coolant Capacity: 9.3 Qts. (8.8L)
  • Radiator Cap: 11-15 psi
  • Thermostat Opens
    • Starts: 176-183°F (80-84°C)
    • Fully Open: 203°F (95°C)

Got questions and comments on Mazda RX7 cooling system specs? Let us know below!

{ 0 comments }

RX7 Automatic Transmission Removal (FD3S)

by NinjaX on July 10, 2010

Automatic transmission removal and installation applies to 1993-1995 Mazda RX7 models.

On Mazda RX7 models with anti-theft radio system, obtain code number from customer to deactivate radio anti-theft system BEFORE disconnecting negative battery cable. To deactivate radio anti-theft system, turn ignition switch to ACC position. Press SCAN and AUTO-M buttons simultaneously until “cod e” is displayed. Press SCAN and AUTO-M buttons again until 4 bars are displayed.
[click to continue…]

{ 0 comments }

Honda S2000 Clutch & Flywheel Removal

by NinjaX on July 1, 2010

Honda S2000 clutch removal applies to 1999-2003 models.

[click to continue…]

{ 0 comments }

Honda S2000 Clutch Slave Cylinder Removal

by NinjaX on July 1, 2010

1. Remove the banjo bolt and washers, then disconnect the clutch hose from the slave cylinder. Plug the end of the clutch hose with a shop towel to prevent brake fluid from coming out.
[click to continue…]

{ 1 comment }

Honda S2000 Clutch Master Cylinder Removal

by spartanix on July 1, 2010

Honda S2000 Clutch Master Cylinder Removal applies to 1999-2003 models.

Do not spill brake fluid on your Honda S2000; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
[click to continue…]

{ 0 comments }